Sorry, what device are you using to supply power once you've flipped the switch? Sure, you can get a (legal, even) manual transfer switch and plug in a little portable generator, but if we're talking about using your car as a power source, this is not going to work.
replyI previously used a portable propane generator for a 30amp inlet to transfer switch. In my test runs it didn’t go that high.
replyToday I could plug in a car that gives off 20amp into the same inlet, it would limit how much load it can carry, but I could stay below 2.4 kw if needed. Why wouldn’t that work?
A lot of houses won’t run off 120V/20A. You’ll also need to kludge around the fact that your house wants 120V/240V.
replyIn any case, serious V2H should support much more than 2kW. An EV with a charger with less than 6kW capacity is almost unheard of. Two EVs should be able to supply twice the current. All that’s technically needed is an charger that is physically capable of operating as an inverter (which I believe adds little cost), some way to derive a neutral (the usual solution is a relay and an autotransformer, again not particularly expensive), and the control logic to convince all of the above to actually operate in this mode.
What about using a step up transformer to send 240V to your panel from the 120V output from some EVs?
reply