upvote
They can like idk, use exact same capiler mounting brackets or mounting screws or pre-cut brake hoses or things like that for vans and trucks, then fit differently sized pads or even the whole calipers each.

That will eliminate like, technically different washers and nuts used for screws to mount the truck calipers that goes this way versus van calipers that comes through this here using slightly longer screws, and that kinds of things add up.

A lot of comment heree seem to be fixated on metal parts, but I think it's more about plastics and wires and electronics. If you could use a common harneess for compacts and sedans and trucks going forward and backward and across... saves a lot of inventory cost.

reply
There already is some commonality within manufacturers. Ever look under the hood or dashboard and notice a connector on the wiring harness that's not connected to anything? That's because they used the same harness as another model that needs that connector. It's cheaper to design, produce, stock, and manage one harness even if there's extra wire and connectors that aren't used on every car. It probably doesn't happen across manufacturers though, but there are SAE standard connector types at least.
reply