> Because an SUV that has 17" wheels can weigh two tons or three tons or more. It can do 120 mph maximum speed or it can go to 160 mph or more.
Didn't I address this objection in advance with the words "performance profile"?
Right now, 95% of SUVs have the same brake performance requirements: under 4 ton, under 160mph, etc. There is no cost saving in making an entirely different wheel assembly for SUVs that require under 3.99 tons and under 159mph, which is what the current manufacturers are doing.
I did not understood your statement like that.
I don’t know about cost savings, but most likely it is about design decisions regarding how a wheel should look like (brake calipers in front of the wheel, in the back).
It's irrelevant in 95% of cars. All of the things I specified are irrelevant in 95% of cars.
A big honking cast iron caliper grabbing 12" rotor that mounts from the back of the hub (to reduce the hat diameter letting you have swept area right up to the wheel bolt circle) can really take some heat and the whole thing will package in a 16" rim. But it ain't gonna be light. I get that we're gonna have different "classes" of performance and you won't put that brake assembly on a new land rover even if it has comparable demands to the old van but there is a whole lot of room to consolidate here.
That will eliminate like, technically different washers and nuts used for screws to mount the truck calipers that goes this way versus van calipers that comes through this here using slightly longer screws, and that kinds of things add up.
A lot of comment heree seem to be fixated on metal parts, but I think it's more about plastics and wires and electronics. If you could use a common harneess for compacts and sedans and trucks going forward and backward and across... saves a lot of inventory cost.