All the manufacturers have been doing it since even before that, with major items like engines and transmissions.
What they haven't been doing is standardising all those other parts that need replacing. For example, standardising on the wheel hub+knuckle for 15-inch, 16-inch, 17-inch and 18-inch wheels will let wheels of the specific size use the same disks, calipers, pads, balljoint, wheel bearing, CV joint and all the sensors (wheel speed, brake, etc).
I see no reason why two different SUVs on 17-inch wheels need completely different brake pads shapes, when both sets have the same surface area, require the same performance profile, etc, but that's what we have now.
You can do the same with almost every mechanical and electrical subsystem in a car, and still have a large variety in cars produced. After all, car manufacturers don't manufacture their own tyres and batteries, do they? They don't manufacture they own wheels.
Even the things that are specific to them, they outsource anyway - they don't each have their own windscreen manufacturer, they outsource that. The already outsource all the glass, all the oils and fluids, all the pipes, etc, it's jus that they produce incompatible designs so that the actual parts manufacturer has to charge a jig setup fee for each of them. Standardising on parts brings in economies of scale.
They’re a Right to Repair aligned business model.
Because an SUV that has 17" wheels can weigh two tons or three tons or more. It can do 120 mph maximum speed or it can go to 160 mph or more.
The math changes really fast when it comes to stopping that SUV down based on those two parameters alone. You can see why different calipers, how many, brake disk size, type (ventilated or not), different sized brake pads.
> Because an SUV that has 17" wheels can weigh two tons or three tons or more. It can do 120 mph maximum speed or it can go to 160 mph or more.
Didn't I address this objection in advance with the words "performance profile"?
Right now, 95% of SUVs have the same brake performance requirements: under 4 ton, under 160mph, etc. There is no cost saving in making an entirely different wheel assembly for SUVs that require under 3.99 tons and under 159mph, which is what the current manufacturers are doing.
I did not understood your statement like that.
I don’t know about cost savings, but most likely it is about design decisions regarding how a wheel should look like (brake calipers in front of the wheel, in the back).
It's irrelevant in 95% of cars. All of the things I specified are irrelevant in 95% of cars.
A big honking cast iron caliper grabbing 12" rotor that mounts from the back of the hub (to reduce the hat diameter letting you have swept area right up to the wheel bolt circle) can really take some heat and the whole thing will package in a 16" rim. But it ain't gonna be light. I get that we're gonna have different "classes" of performance and you won't put that brake assembly on a new land rover even if it has comparable demands to the old van but there is a whole lot of room to consolidate here.
That will eliminate like, technically different washers and nuts used for screws to mount the truck calipers that goes this way versus van calipers that comes through this here using slightly longer screws, and that kinds of things add up.
A lot of comment heree seem to be fixated on metal parts, but I think it's more about plastics and wires and electronics. If you could use a common harneess for compacts and sedans and trucks going forward and backward and across... saves a lot of inventory cost.